Radium Engineering - Universal Fuel Level Senders
Available: In stock
SKU: Radium Engineering-20-0247-13
On all products!
30 days return policy
Float-style fuel level sending units with standard SAE 5-bolt mounting pattern. Easy to install using the supplied hardware and Deutsch connectors (gauge not included). Fits most fuel cells and extensively used with the Radium Fuel Cell Surge Tank. This rugged design features a FR4 conformal-coated PCB, epoxy potted electrical terminals, and an anodized surface finish making it suitable for use with gasoline, diesel, and all alcohol based fuels including methanol, ethanol, E85, etc.
Made here in Portland, USA.
-All level senders are 0 ohms empty to 90 ohms full. This 0-90 ohm range is common with many OEM gauges.
-Radium does not sell fuel level gauges, but a popular option is this Autometer Fuel Level Gauge
-To test the sender, measure the resistance between the two wires while tipping the sender to allow the float to move.
-Fuel level senders carry a 1 year warranty through Radium Engineering.
ALWAYS MEASURE THE INSIDE DEPTH OF THE FUEL CELL BEFORE SELECTING SENDER LENGTH.
If using a Spare Tire Fuel Cell, select the 8" long sender.
12VDC with unit connected to a single electric receiver gauge that utilizes an AC resistance curve (shown below).
When mounted properly, the gasket seal will withstand an internal tank pressure of over 6psi conforming to SAE J1810.
-Level Sensing Probe
-SAE 5-Bolt Gasket
-Stainless Bolts 10-32 (x5)
-Nylon Sealing Washers (x5)
-Deutsch DT 2P Connector
-Deutsch DT Sockets (x2)
20-0439 12AN ORB to 5-Bolt SAE Adapter
This adapter is commonly used with old FCST units (20-014X-XX) which had a small vent. It converts the fuel level flange to a large 12AN ORB vent.
NOTE: a fuel level sender cannot be used with this adapter in place.